| Home |
| Search |
| Today's Posts |
|
#1
19-02-2005, 02:07 PM
|
|||
|
|||
Flywheel removal on B&S lawnwmower engine to get to ignition points ?
I want to remove the flywheel on 2 rotary mowers with 3-4.5 B&S
engines . The method I ahve used it the past on similar engines isn't working . - ( I have removed the nut , squirted penatrant around the sahft, tapped the end of the shaft ( protected by a wood block ) while a helper prys on the flywheel .) Waht else can I do ? |
|
#2
19-02-2005, 05:23 PM
|
|||
|
|||
|
wrote in message ... I want to remove the flywheel on 2 rotary mowers with 3-4.5 B&S engines . The method I ahve used it the past on similar engines isn't working . - ( I have removed the nut , squirted penatrant around the sahft, tapped the end of the shaft ( protected by a wood block ) while a helper prys on the flywheel .) Waht else can I do ? Go down to the hardware store at blow the five bucks for a "flywheel puller" so you don't really screw something up! |
|
#3
28-02-2005, 12:09 PM
|
|||
|
|||
|
Try using a stanley or any brand pulley puller, worked for me a couple days
ago on a 10hp briggs. wrote in message ... I want to remove the flywheel on 2 rotary mowers with 3-4.5 B&S engines . The method I ahve used it the past on similar engines isn't working . - ( I have removed the nut , squirted penatrant around the sahft, tapped the end of the shaft ( protected by a wood block ) while a helper prys on the flywheel .) Waht else can I do ? |
|
#4
01-03-2005, 07:52 AM
|
|||
|
|||
|
|
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Briggs & Stratton 16 HP engine-points actuating rod not moving enough ? | Lawns | |||
| 8HP Briggs Flywheel Key Shearing - any ideas? | Lawns | |||
| Ignition switch replacement problem | Lawns | |||
| Briggs & Strattin Flywheel removal | Lawns | |||
| Flywheel / magneto removal Sears Tecumseh engine ? | Lawns | |||
Linear Mode
