yup, that's what i used.. except mine was about 8"x12" and i cut it up
into smaller pieces (had about 12 holes where i put nails through the liner)

cpemma wrote:
"Bob" wrote in message
t...

I have been dealing with a leak since the winter and I have finally found
it! I guess the very thick ice on my pond over the winter plus me trying

to

clear a hole in the ice caused a hole about the size of a nickel in my
liner. Fortunately it's about six inches below the surface on the side so
it's easy to get at but I have one question...what is the best way to

repair

a hole in an EPDM rubber liner? I have never done this and I don't know
what to use. Any help out there? Thanks!


Your local pond shop should sell plasters. Very, very sticky with a silicone
paper covering the gluey side, mine came about 1" wide, sold by the foot.